Main linac lattice design and optimization for <I>E</I><SUB>cm</SUB>=1 TeV CLIC

WANG Yi-Wei; SCHULTE Daniel; GAO Jie

doi:10.1088/1674-1137/38/6/067009

Chinese Physics C> 2014, Vol. 38> Issue(6) : 067009 DOI: 10.1088/1674-1137/38/6/067009

Main linac lattice design and optimization for E_cm=1 TeV CLIC

Abstract
HTML
Reference
Related

PDF

Abstract：
The Compact Linear Collider (CLIC) is a future e⁺e^- linear collider. The CLIC study concentrated on a design of center-of-mass energy of 3 TeV and demonstrated the feasibility of the technology. However, the physics also demands lower energy collision. To satisfy this, CLIC can be built in stages. The actual stages will depend on LHC results. Some specific scenarios of staged constructions have been shown in CLIC Concept Design Report (CDR). In this paper, we concentrate on the main linac lattice design for E_cm=1 TeV CLIC aiming to upgrade from E_cm=500 GeV CLIC and then to E_cm=3 TeV one. This main linac accelerates the electron or positron beam from 9 GeV to 500 GeV. A primary lattice design based on the 3 TeV CLIC main linac design and its optimization based on the beam dynamics study will be presented. As we use the same design principles as 3TeV CLIC main linac, this optimization is basically identical to the 3 TeV one. All the simulations results are obtained using the tracking code PLACET.

References

[1]

Aicheler M, Burrows P, Draper M et al. CLIC Conceptual Design Report, CERN-2012-007[2] Balakin V, Novakhatsky A, Smirnow V. Proc. of 12th Int. Conf. on High Energy Accelerators, Fermilab, 1983[3] Schulte D. Beam-Based Alignment in the New CILC Main Linac, CLIC-Note-804[4] Latina A et al. Recent Improvements in the Tracking Code PLACET. Proc. of 11th biennial European Particle Accelerator Conference, Genoa, Italy, 2008[5] Baklakov B A et al. Proc. of IEEE Particle Accelerator Conf., San Francisco, USA, 1991. 3273-3275[6] Schulte D. The Lectures on Main Linac. 5th Linear Collider School. 2010[7] Schulte D. Multi-Bunch Calculations in the CLIC Main Linac, CLIC-Note-805[8] Schulte D. Emittance Preservation in the Main Linac of CLIC. Proc. 23rd IEEE Particle Accelerator Conf., Vancouver, Canada. 2009. 3808-3810[9] Raubenheimer Tor O. The Generation and Acceleration of Low-Emittance Flat Beams for Future Linear Collider (Ph.D. thesis). Stanford University, 1992, Chapter 3.4.1.1

[1]	Gang Xu , Yi Jiao , Yue-Mei Peng . ESRF-type lattice design and optimization for the High Energy Photon Source. Chinese Physics C, 2016, 40(2): 027001. doi: 10.1088/1674-1137/40/2/027001
[2]	FU Zi-Wen . I=1/2 low-lying mesons in lattice QCD. Chinese Physics C, 2015, 39(8): 083101. doi: 10.1088/1674-1137/39/8/083101
[3]	MENG Cai , TANG Jing-Yu , PEI Shi-Lun , YAN Fang . Mismatch study of C-ADS main linac. Chinese Physics C, 2015, 39(9): 097002. doi: 10.1088/1674-1137/39/9/097002
[4]	JIAO Yi , XU Gang . PEPX-type lattice design and optimization for the High Energy Photon Source. Chinese Physics C, 2015, 39(6): 067004. doi: 10.1088/1674-1137/39/6/067004
[5]	YANG Lei , QIN Bin , YANG Jun , LIU Xia-Ling , TAN Ping , HU Tong-Ning . Optimization of the lattice function in the planar undulator applied for terahertz FEL oscillators. Chinese Physics C, 2014, 38(3): 037004. doi: 10.1088/1674-1137/38/3/037004
[6]	GAO Xiang , YANG Jian-Cheng , XIA Jia-Wen , CHAI Wei-Ping , SHI Jian , SHEN Guo-Dong . SHER-HIAF ring lattice design. Chinese Physics C, 2014, 38(4): 047002. doi: 10.1088/1674-1137/38/4/047002
[7]	YAN Fang , LI Zhi-Hui , MENG Cai , TANG Jing-Yu , SUN Biao . Physics design for the C-ADS main linac based on two different injector design schemes. Chinese Physics C, 2014, 38(2): 027004. doi: 10.1088/1674-1137/38/2/027004
[8]	SUN Lie-Peng , ZHAO Hong-Wei , SUN Zhou-Ping , HE Yuan , SHI Ai-Min , XIAO Chen , DU Xiao-Nan , ZHANG Cong , ZHANG Zhou-Li . Design study of the SSC-LINAC re-buncher. Chinese Physics C, 2013, 37(2): 027002. doi: 10.1088/1674-1137/37/2/027002
[9]	YANG Liu , LU Xiang-Yang , QUAN Sheng-Wen , YAO Zhong-Yuan , LUO Xing , ZHOU Kui . Electromagnetic design and optimization of a superconducting quarter wave resonator. Chinese Physics C, 2013, 37(2): 027001. doi: 10.1088/1674-1137/37/2/027001
[10]	BAI Zheng-He , WANG Lin , JIA Qi-Ka , LI Wei-Min . Lattice optimization for the HLS-Ⅱ storage ring. Chinese Physics C, 2013, 37(1): 017001. doi: 10.1088/1674-1137/37/1/017001
[11]	ZHAO Wei , TANG Xiao , SHI Rong-Jian , HOU Mi . Coupler design for an L-band electron linac. Chinese Physics C, 2012, 36(8): 765-768. doi: 10.1088/1674-1137/36/8/015
[12]	GAO Wei-Wei , WANG Lin , LI Wei-Min , HE Duo-Hui . Low emittance lattice optimization using a multi-objective evolutionary algorithm. Chinese Physics C, 2011, 35(9): 859-864. doi: 10.1088/1674-1137/35/9/014
[13]	WANG Dou , GAO Jie . Single-bunch emittance dilution in the perfect ILC main linac. Chinese Physics C, 2011, 35(3): 296-300. doi: 10.1088/1674-1137/35/3/016
[14]	WANG Dou , GAO Jie . Effects of machine errors on the ILC main linac. Chinese Physics C, 2011, 35(6): 585-589. doi: 10.1088/1674-1137/35/6/015
[15]	WANG Zhi-Jun , HE Yuan , WU Wei , YANG Ya-Qing , XIAO Chen . Design optimization of the APF DTL in the SSC-linac. Chinese Physics C, 2010, 34(10): 1639-1642. doi: 10.1088/1674-1137/34/10/017
[16]	MAO Cheng-Wen , XI Zai-Jun , YU Xiao-Han , XIAO Ti-Qiao . Design optimization of a tapered mirror for microfocusing optics. Chinese Physics C, 2009, 33(8): 687-690. doi: 10.1088/1674-1137/33/8/017
[17]	HE Fei-Si , HAO Jian-Kui , ZHANG Bao-Cheng , ZHAO Kui . Design of a capacitive main power coupler for RF superconducting accelerators. Chinese Physics C, 2008, 32(7): 584-588. doi: 10.1088/1674-1137/32/7/015
[18]	LI Jia-Cai , ZHANG Liang-Sheng , HU Chun-Liang , WU Yuan-Ming , CUI Xiang-Zong , LIU Zheng-Quan , ZHANG Shao-Ping , ZHOU Bao-Qing , ZHENG Lin-Sheng . Design and Performance Measurement of the 1GeV/c Multiparticle Magnetic Spectrometer in the BEPC-LINAC Test Beam. Chinese Physics C, 2005, 29(1): 55-61.
[19]	Zheng Bo , Guo Shuohong . Exact Solution for a 1 + 1 Dimensional Lattice U (1) Gauge Model. Chinese Physics C, 1990, 14(S2): 163-167.
[20]	Ma Jimao , Mao Huishun , Bai Jingzhi , Xie Peipei , Yan Jie , Wang Yaohui , Mao Zepu , Liu Rongguang , Shen Benwei , Song Xiaofei , Zhou Jie , Wu Zhendong , Fan Qun , Jin Yan , Rong Gang . The Design and Construction of the BES Main Drift Chamber. Chinese Physics C, 1990, 14(S4): 325-337.

Access

Get Citation

WANG Yi-Wei, SCHULTE Daniel and GAO Jie. Main linac lattice design and optimization for E_cm=1 TeV CLIC[J]. Chinese Physics C, 2014, 38(6): 067009. doi: 10.1088/1674-1137/38/6/067009

WANG Yi-Wei, SCHULTE Daniel and GAO Jie. Main linac lattice design and optimization for E_cm=1 TeV CLIC[J]. Chinese Physics C, 2014, 38(6): 067009. doi: 10.1088/1674-1137/38/6/067009 shu

RIS(for EndNote,Reference Manager,ProCite)

BibTex

Txt

Milestone

Received: 2013-08-07
Revised: 1900-01-01

Article Metric

Article Views(1506)
PDF Downloads(241)
Cited by(0)

Policy on re-use

To reuse of subscription content published by CPC, the users need to request permission from CPC, unless the content was published under an Open Access license which automatically permits that type of reuse.

通讯作者: 陈斌, bchen63@163.com

1.
沈阳化工大学材料科学与工程学院沈阳 110142

Main linac lattice design and optimization for E_cm=1 TeV CLIC

Corresponding author: SCHULTE Daniel,

Received Date: 2013-08-07

Accepted Date: 1900-01-01

Available Online: 2014-06-05

Abstract: The Compact Linear Collider (CLIC) is a future e⁺e^- linear collider. The CLIC study concentrated on a design of center-of-mass energy of 3 TeV and demonstrated the feasibility of the technology. However, the physics also demands lower energy collision. To satisfy this, CLIC can be built in stages. The actual stages will depend on LHC results. Some specific scenarios of staged constructions have been shown in CLIC Concept Design Report (CDR). In this paper, we concentrate on the main linac lattice design for E_cm=1 TeV CLIC aiming to upgrade from E_cm=500 GeV CLIC and then to E_cm=3 TeV one. This main linac accelerates the electron or positron beam from 9 GeV to 500 GeV. A primary lattice design based on the 3 TeV CLIC main linac design and its optimization based on the beam dynamics study will be presented. As we use the same design principles as 3TeV CLIC main linac, this optimization is basically identical to the 3 TeV one. All the simulations results are obtained using the tracking code PLACET.

HTML

Reference (1)

Main linac lattice design and optimization for E_cm=1 TeV CLIC

Abstract：

References

Access

Article Metrics

Metrics

通讯作者: 陈斌, bchen63@163.com

Email This Article

Main linac lattice design and optimization for E_cm=1 TeV CLIC

Corresponding author: SCHULTE Daniel,

HTML

目录

Main linac lattice design and optimization for Ecm=1 TeV CLIC

Abstract：

References

Access

Article Metrics

Metrics

通讯作者: 陈斌, bchen63@163.com

Email This Article

Main linac lattice design and optimization for Ecm=1 TeV CLIC

Corresponding author: SCHULTE Daniel,

HTML

目录

Main linac lattice design and optimization for E_cm=1 TeV CLIC

Main linac lattice design and optimization for E_cm=1 TeV CLIC